HAYBUSA LAND SPEED TAIL SECTION - Instructions for tail support bracket / electronics tray installation and subframe prep

Below are the instructions for tab removal on a first generation Hayabusa subframe in order to install our tail support bracket / electronics tray GSX13LSRB5.

This bracket stabilizes and supports the rear of the tail section and gives you plenty of room to mount power commander, boost controllers and a bottle of water for after the pass. Heck you could probably pack some lunch and fit it back there!

This bracket is designed for use with a Gen 1 subframe.

Click pictures for a larger view.

Before cutting

Remove rear seat lock.

All the tabs that need to be removed/cut off for the tray to sit down inside the subframe are marked with an arrow, red marks and are numbered (1-7). See close ups below.

Click for a larger view

Right side of subframe. Cut off the following tabs:

1. Small square hook. Remove top part only! Do not remove square bottom part of bracket.

2. Round bungee hook #1. Remove completely.

3. Round bungee hook #2. Remove completely.

Click for a larger view

Left side of subframe. Cut off the following tabs:

4. Grab handle. Remove completely and grind flush with frame.

5. Small square hook. Remove top part only! Do not remove square bottom part of bracket.

6. Round bungee hook #3. Remove completely.

7. Round bungee hook #4. Remove completely.

Click for a larger view

After cutting

This is what it should look like after cutting. Side angles below.

Click for a larger view

Right side of subframe.

Click for a larger view

Left side of subframe.

Click for a larger view

Tray installed

Double check the marks line up then drill the holes as marked on the tray. You'll be using the stock mounting points as marked on the left to install the tray to subframe.

Click for a larger view

That's it, you're ll done! Install the subframe back on your bike and sit the GSX13LSRB3 tail down over the top of it.

Click for a larger view

To order call 760-598-3366 NOW!